Pullers & Separators

Universal set for turning off out worn bolts, etc. Practical package for universal use. Complete easy-to-manage package. Almost all components available as replacement parts, time-saving order process thanks to numbering system. Instructions and conversion table in the cover. Secure storage in special foam. Personal KUKKO-Chip-Code. Do not use any electrical or pneumatic servo screwdrivers or hammer drills. Protective blanket required. Protective goggles required. Screw Thread (Metric) M5 - M16 Drill Diameter (Metric) 3, 2 - 8, 7mm

For extracting inner bearings, bearing outer rings and bushings. KUKKO internal extractors can be combined with counter supports and slide hammers. When combined with the internal extractors, extensions from series 21-V enable deeper bearings to be extracted. Spare parts are available for internal extractor sizes 21-89 and 21-90. The 2-shell design with extra large grasp edges ensures safe extraction. The internal extractors are equipped with an internal safety stop to protect against excess spreading and overloading. Mechanical pressure screw. Do not use any electrical or pneumatic servo ...

For extracting ball pins when dismantling ball joints, track-rod ends on track rods. Almost all components available as replacement parts, time-saving order process thanks to numbering system. Bell-shaped design, Direct pressure on the ball pin, Ideal if enough space is available, Working without damage, Made from sturdy, alloyed, hardened and tampered steel, galvanized. Milled thread treated with special coating. A torque wrench is recommended for the drive Never use an electric- or pneumatic-powered impact/hammer drill for driving a pulling tool. Protective blanket required. Protective ...

For extracting inner bearings, bearing outer rings and bushings. KUKKO internal extractors can be combined with counter supports and slide hammers. When combined with the internal extractors, extensions from series 21-V enable deeper bearings to be extracted. Spare parts are available for internal extractor sizes 21-89 and 21-90. The 2-shell design with extra large grasp edges ensures safe extraction. The internal extractors are equipped with an internal safety stop to protect against excess spreading and overloading. Mechanical pressure screw. Do not use any electrical or pneumatic servo ...

For splitting tight or over-twisted nuts without damaging the bolt thread of quality grades 6. The nut splitters band provides additional support when turning the chisel back. Chisel available as a replacement part, time-saving order process thanks to numbering system. Very sharp cutting through facet cut. Hardened chisel cutting edge. Gently turn the chisel in the other direction by pulling back. The splitting chisels of the nut splitters are wearing parts. Blunt, pitted or broken chisels must be replaced immediately. Do not use any electrical or pneumatic servo screwdrivers or hammer ...